Synthesis, Characterization, and Molecular Dynamics Analysis of Ultrathin Amorphous Carbon Films

Synthesis, Characterization, and Molecular Dynamics Analysis of Ultrathin Amorphous Carbon Films
Author :
Publisher :
Total Pages : 133
Release :
ISBN-10 : OCLC:904238361
ISBN-13 :
Rating : 4/5 (61 Downloads)

Book Synopsis Synthesis, Characterization, and Molecular Dynamics Analysis of Ultrathin Amorphous Carbon Films by : Na Wang

Download or read book Synthesis, Characterization, and Molecular Dynamics Analysis of Ultrathin Amorphous Carbon Films written by Na Wang and published by . This book was released on 2013 with total page 133 pages. Available in PDF, EPUB and Kindle. Book excerpt: Increasing demands for high magnetic storage capacity have led to the increase of the recording area density by more than 100,000 times over the past 30 years. Among all the approaches considered to increase the area density, reducing the magnetic spacing is an effective solution that directly impacts the thickness and quality of the carbon overcoat. One of the methods of carbon overcoat deposition is chemical vapor deposition, which uses carbon-containing precursor gases as the source of carbon radicals and atoms to form the carbon overcoat. The produced carbon film is characterized by high hydrogen content (20%-50%), depending on the carbon-to-hydrogen ratio of the precursor gas and process parameters. Because of the hydrogen content, CVD-deposited hydrogenated amorphous carbon (a-C:H) deposited by CVD exhibit density of 1.7-2.2 g/cm3, which is much lower than the density (~3 g/cm3) of hydrogen-free amorphous carbon (a-C) films deposited by filtered cathodic vacuum arc (FCVA). The superior nanomechanical/tribological properties of FCVA-deposited a-C films have been widely-reported; however, most studies have examined relatively thick (tens of nanometers) a-C films, while current demands require much thinner films of thickness in the range of 1-4 nm. FCVA-deposited a-C films overcoats are desirable protective overcoats for HDDs provided they can maintain their demonstrated high quality even for thickness as low as 1 nm. In this dissertation, an in-depth study of the structure of FCVA-deposited a-C films deposited on silicon was carried out using high-resolution transmission electron microscopy (HRTEM) and analytical electron energy loss spectroscopy (EELS). Both low- and high (core)-loss EELS spectra of Si and C were analyzed to determine the elemental content and through-thickness structure of ~20-nm-thick a-C films. Calculations of atomic carbon hybridization based on EELS spectra were used to track the film structure evolution. The average content of carbon hybridization in the top few nanometers of the a-C film, determined from EELS analysis, was found to be ~50%, much less than 73% of the bulk film. This multilayer structure was also validated by X-ray photoelectron spectroscopy (XPS). Results indicate that the minimum thickness of a-C films deposited by the FCVA method under conditions of optimum substrate bias ( -100 V) should be equal to 3-3.5 nm, which is the total thickness of the buffer and surface layers. The effects of other important FCVA process parameters on film growth were also investigated to explore the prospect of further decreasing the a-C film thickness. The incidence angle effect of energetic C+ ions bombarding onto the growing film surface was studied in terms of the deposition rate, topography, and film structure. Cross-section TEM measurements combined with Monte Carlo (T-DYN) simulations revealed that the deposition yield (rate) is independent of the ion fluence but varies with the incidence angle according to a relationship derived from sputtering theory. XPS and atomic force microscopy (AFM) studies were also performed to examine carbon hybridization and film topography. The optimum incidence angle for FCVA deposition was found equal to 45o. A relatively new technology that shows potential for further breakthroughs in magnetic recording is heat-assisted magnetic recording (HAMR). This technology utilizes a tightly focused laser beam to heat and temporarily reduce the coercivity of magnetic nanodomains below that of the magnetic field applied by the magnetic head. Impulsive laser heating (typically


Synthesis, Characterization, and Molecular Dynamics Analysis of Ultrathin Amorphous Carbon Films Related Books

Synthesis, Characterization, and Molecular Dynamics Analysis of Ultrathin Amorphous Carbon Films
Language: en
Pages: 133
Authors: Na Wang
Categories:
Type: BOOK - Published: 2013 - Publisher:

DOWNLOAD EBOOK

Increasing demands for high magnetic storage capacity have led to the increase of the recording area density by more than 100,000 times over the past 30 years.
Molecular Dynamics Modeling of Ultrathin Amorphous Carbon Films
Language: en
Pages:
Authors:
Categories:
Type: BOOK - Published: 1995 - Publisher:

DOWNLOAD EBOOK

Synthesis and Characterization of Amorphous Carbon Films for Magnetic Storage Technology
Language: en
Pages: 119
Authors: Jun Xie
Categories:
Type: BOOK - Published: 2015 - Publisher:

DOWNLOAD EBOOK

Increasing demands for high magnetic storage capacity have led to the increase of the recording area density, mainly by reducing the distance between the magnet
Sputtering Deposition and Characterization of Ultrathin Amorphous Carbon Films
Language: en
Pages: 486
Authors: Wei Lu
Categories:
Type: BOOK - Published: 1999 - Publisher:

DOWNLOAD EBOOK

Properties and Characterization of Amorphous Carbon Films
Language: en
Pages: 714
Authors: J.J. Pouch
Categories: Technology & Engineering
Type: BOOK - Published: 1991-01-01 - Publisher: Trans Tech Publications Ltd

DOWNLOAD EBOOK

Amorphous, hydrogenated carbon (AHC) films can be deposited on various substrates using several techniques, e.g. plasma deposition and ion beam deposition. The