Download or read book Analysis and Design of Quality Link Metrics for Routing Protocols in Wireless Networks written by Nadeem Javaid and published by . This book was released on 2010 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt: This dissertation endeavors to contribute enhancements in goodputsof the IEEE 802.11-based Wireless Multi-hop Networks (WMhNs).By performing exhaustive simulations, for the deep analysis and detailed assessment of both reactive (AODV, DSR, DYMO) and proactive (DSDV, FSR, OLSR) protocols for varying mobilities, speeds, network loads and scalabilities, it is observed that a routing link metric is a significant component of a routing protocol. In addition to finding all available paths, the fastest end-to-end route is selected by a link metric for the routing protocol. This study aims the quality routing. In the class of quality link metrics, Expected Transmission Count (ETX) is extensively used. Thus, the most recently proposed ETX-based metrics have been analyzed. Though, newly developed metrics over perform ETX but still they can be improved. By profound analysis and particularized comparison of routing protocols depending upon their classes (reactive and proactive) and ETX-based metrics, we come to realize that users always demand proficient networks. In fact, WMhNs are facing several troubles which they expect to be resolved by the routing protocol operating them. Consequently, the protocol depends upon the link metric for providing quality paths. So, we identify and analyze the requirements to design a new routing link metric for WMhNs. Because, considering these requirements, when a link metric is proposed, then : firstly, both the design and implementation of the link metric with a routing protocol become easy. Secondly, the underlying network issues can easily be tackled. Thirdly, an appreciable performance of the network is guaranteed. Keeping in view the issues of WMhNs, increasing demands of users and capabilities of routing protocols, we propose and implement a new quality link metric, Interference and Bandwidth Adjusted ETX (IBETX). As, MAC layer affects the link performance and consequently the route quality, the metric therefore, tackles the issue by achieving twofold MAC-awareness. Firstly, interference is calculated using cross-layered approach by sending probes to MAC layer. Secondly, the nominal bit rate information is provided to all nodes in the same contention domain by considering the bandwidth sharing mechanism of 802.11. Like ETX, our metric also calculates link delivery ratios that directly affect throughput and selects those routes that bypass dense regions in the network. Simulation results by NS-2 show that IBETX gives 19% higher through put than ETX and 10% higher than Expected Throughput (ETP). Our metric also succeeds to reduce average end-to-end delay up to 16% less than Expected Link Performance (ELP) and 24% less than ETX.